What are the basic features of various bearings?
- Jul 19, 2018 -

The bearing is washed with kerosene and pressed into the bearing seat. Fill the roller of the bearing outer ring with Shell No. three lithium grease to 2/3 full. Apply the net hand to uniform, install the NTN bearing cap and press the bearing pressure cap with the fastening bolt with the bolt. The bearing is the detachable cylindrical roller bearing of the inner and outer sleeve, and the inner suit should be set in the bearing. On the rotating shaft and in place; install the bearing housing on the chassis, if grease injection holes must be aligned. Fasten the tight bolt bearing seat with the fastening bolts of the bolt. The inner and outer eccentricity blocks are mounted on the rotating shaft and in place. The shaft key should be loaded into the key slot and reload the outer eccentric block, and the shaft is mounted on the rotating shaft by the retaining ring; the eccentric block fasten the bolt and turns the adjustable eccentric block to make it to the angle position before unloading and tighten its tightness. Fixed bolt. After the above assembly is completed, the shaft should have a certain axial movement; the shield on both ends of the vibrating motor is fastened with screws.

The needle bearing is a roller bearing with a cylindrical roller. Relative to its diameter, the roller is both thin and long. This roller is called a needle roller. The needle roller bearing is equipped with a thin and long roller (the roller diameter D<5mm, L/D>_2.5, L is the roller length), so the radial structure is compact and its inner diameter and load capacity are at the same time as other types of bearings, and the outer diameter is small. It is especially suitable for supporting results with limited size of radial installation. According to the different use situation, we can choose the bearing or needle roller and the cage component without inner ring. At this time, the surface of the shaft neck and the surface of the shell hole are directly used as the inner and outer rolling surface of the bearing. A product intended to be used.


INFORMATION

  • >Delivery information
  • >Discout
  • >Sitemap
  • >Privacy Policy
  • >FAQs
  • >Terms&Condition

SERVICE

  • >Account
  • >Wishlist
  • >Shopping Cart
  • >Return Policy
  • >Special
  • >Lookbook

Remark:

.

SUBMIT

.